How to install the ferrule

The installation method of the ferrule joint:
(1) The tube fittings that need to be pickled should be pickled first as required;

(2) Cut the pipe with sawing machine or special pipe cutting machine and other equipment according to the required length. It is absolutely not allowed to use melting (such as flame cutting) or grinding wheel cutting; remove the inner and outer burrs, metal chips and dirt on the pipe end; remove the rust prevention of pipe joints agent and dirt; at the same time, ensure the roundness of the pipe;

(3) Put the nut and the ferrule into the pipe successively, and the cutting edge (small diameter end) of the ferrule is at least 3mm away from the pipe mouth, and then insert the pipe into the taper hole in the joint body until it reaches it;

(4) Slowly tighten the nut, while turning the tube until it does not move, then tighten the nut 2/3 to 4/3 turns;

(5) Disassemble and check whether the ferrule has been cut into the pipe and whether the position is correct. The ferrule is not allowed to have axial movement, and can be rotated slightly;

(6) Re-tighten the nut after passing the inspection.

佛山市玖州自控技术有限公司

电话：0757-86680382 13929954058 汪先生
传真：0757-86680381
邮箱：chenglin.wang@joecontrol.com
地址：佛山市南海区桃园东路88号慧泉科技产业中心第三栋5楼

关注微信公众号

网站建设：中企动力佛山

SEO